Aerospace structures combine high loads, extreme weight sensitivity and dissimilar metals in contact. This page organises the fastening routes for airframe and equipment joints around three verifiable targets: ≥1,400 MPa static strength, 2×10⁷ fatigue cycles and reliable galvanic isolation.
Aerospace joints rarely allow bigger diameters, so the fastening route has to gain strength, cut mass and separate metals at the same time. Each point below cites a verifiable source.
Where a joint cannot grow in size, strength must grow instead: grade-14.9 alloy-steel bolts reach ≥1,400 MPa tensile strength with a verified fatigue life of 2×10⁷ cycles under vibration typical of airframe structures.
ZT68 600 MPa high-strength aluminum bolts replace steel in secondary structure joints, while titanium cold-headed parts cover positions where aluminum is not allowed — both routes cut weight and keep the joint stiffness the design assumes.
Aluminum sheets fastened with steel screws form a galvanic couple. Bonded and blind-riveted joints separate the metals, double-layer locking washers hold preload under vibration, and sealing plugs close housings up to IP68.
Each line links to a product page with dimensions, materials and verification data.
We reply with a fastening route per joint — grade, material, locking and sealing — plus matched samples and acceptance criteria you can apply.